Complete ignition with VEC coil and 6 volt light coil for left-turning two-speed engines on mopeds / mopeds such as Puch X30 Sport, Puch X30 Velux / Sachs 50/2, Sachs 503 or Zündapp Belmondo.
The set includes all parts such as fastening screws, flywheel nut with wedge, ignition plate, ignition and light coil, pole wheel and spark plug connector.
The components are supplied individually and still need to be assembled.
Direction of rotation: Left (counterclockwise)
Operating voltage of the light system: 6 volts
Wattage of the light system: 17 watts
Ø inside flywheel: 90 mm
Attention: A spark plug connector with at least 10 kOhm discharge must be used, the spark plug must not be discharged!
With Beru or MERIT spark plug connectors, misfiring may occur.
Adjusting the ignition:
In principle, nothing needs to be adjusted on the ignition. Only the ignition plate can be turned slightly for a perfect ignition spark, the rest is regulated by the ignition chip.
In the basic setting, the three fastening screws of the ignition plate are located in the middle of the slotted holes. Pre-tensioning is achieved by turning the ignition plate against the direction of motor rotation. Fine adjustment is carried out at medium speed using the strobe light. The electrode gap on the spark plug must be set to 0.7-0.8 mm in advance.
The ignition timing adjustment gun as well as other tools and individual parts for your ignition can be found in the accessories section.
The set includes the following fixed parts:
Manufacturer: GPO · Pony spare part no.: A2133, A5532 · Sachs spare part no.: 0265 140 005, 0265 206 000
Manufacturer: GPO · Material: Steel · Tension: 6 V · Performance: 17 W · Direction of rotation: left · Ø cone small inside: 11.5 mm · Ø cone large inside: 15 mm · Cone length: 18.5 mm · Cone ratio: 1:5 · Ø Internal flywheel: 91.1 mm · Ø Flywheel outside: 116.5 mm · Thread type: MF26x1.5 (fine pitch thread) · Thread length: 8 mm · Weight: 900 g · Height: 36.1 mm · Pony spare part no.: A2600 · Sachs spare part no.: 0286 175 005
Manufacturer: NGK · Material: Plastic, Rubber · Color: black · Ø cable: 5 mm, 7 mm · Spark plug socket: SAE · Cable available: No · Suppressed: Yes · Resistance: 10000 Ω
Manufacturer: GPO · Material: Steel · Surface: blue galvanized · Area of application: Standard · Nut type: Flange nut · Drive: External hexagon · Thread type: MF10x1 (fine pitch thread) · Ø outside: 18.8 mm · Height: 8.9 mm · Width across flats SW: 14 mm · Pony spare part no.: A4513 · Sachs spare part no.: 0942 072 102
Material: Steel · Total length: 9.15 mm · Width: 3 mm · Height: 3.7 mm
Manufacturer: swiing® revival parts · Material: Steel · Surface: blue galvanized · Alternative version of the Puch spare part no.: 900.3202, 900.1509
Tension: 6 V · Performance: 17 W · Ø Internal flywheel: 90 mm · Height: 25.2 mm · Total length: 76.8 mm · Mounting type: Screws · Number of fixing points: 2 pcs · Ø mounting hole: 4.1 mm · Hole spacing: 54 mm · Area of application: Standard, Original
Manufacturer: VEC · Place of use: Internal (in the ignition) · Ø Internal flywheel: 90 mm · Ø cable holder: 5 mm · Cable length: 140 mm, 420 mm · Color: black · Total length: 77 mm · Height: 48 mm · Mounting type: Screws · Number of fixing points: 2 pcs · Ø mounting hole: 4.6 mm · Hole spacing: 54 mm · Area of application: Standard, Original, Performance
Details
| Manufacturer | VEC, GPO |
| Tension | 6 V |
| Area of application | Tuning, Standard |
| Performance | 17 W |
| Direction of rotation | left |
| Ø Internal flywheel | 90 mm |
| Ø cable | 5 mm |
| Mounting type | Screws |
Suitable for the following models
| Puch | ZA50 (Fahrtwindgekühlt) ZA50 (Gebläsegekühlt) Z50 (X30 Sport) Z50 (X30 Velux) 2-Gang MS, MV, MV50 3-Gang VSD, DS, VZ, MC |
| Sachs | 50 (Fahrtwind, 1.25 / 1.5 PS, DE) 502 (Saxonette) - AL, AML 50/2 - L CH (0.8 PS), ML CH (0.8 PS), MB (2.6 PS), MLB (2.6 PS) 50/3 50/4 - MLFB (2.6 PS), LKH (4.5 PS) 503 - AAL, ABL, 2AL / 2BL, AB, AC, ADV 505 (mit Tretwelle) - 1A (AT), 2 A (HG) 535 |
| Zündapp Belmondo |
Accessories & related products
GPO flywheel trigger M26x1.5 / M22x1.5 | Puch, Sachs, Beta 521
Width across flats (trigger): 27 mm · Manufacturer: GPO · Clamping depth: 10 mm · Material: Steel · Area of application: (Dis)assembly tool · Surface: blackened · Thread type: MF22x1.5 (fine pitch thread) · Thread type: MF26x1.5 (fine pitch thread) · Total length: 55 mm · Total length: 75 mm · Width across flats Screw: 19 mm · Strength class: 8.8 · Number of components: 1 pcs
11,20 EUR
HPI racing ignition 12V with light 60W
Manufacturer: HPI · Material: Aluminum · Material: Steel · Ø cable: 7 mm · Light coil voltage: 12 V · Tension: 12 V · Performance: 60 W · Direction of rotation: left · Direction of rotation: right · Ø mounting plate: 90 mm · Ø Internal flywheel: 61.5 mm · Mounting type: Screws · Ø Flywheel outside: 71.5 mm · Number of fixing points: 6 pcs · Area of application: Tuning · Weight: 340 g
338,00 EUR
swiing® ingenious flywheel holder 3 pins (Bosch / Ducati flywheels)
Ø inside: 27 mm · Manufacturer: swiing® ingenious parts · Area of application: Special tool · Material: Steel · Surface: blue galvanized · Surface: rubberized · Diameter: 19 mm · Total length: 290 mm · Height: 80 mm · Ø outside: 93 mm · Thickness: 5 mm · Number of components: 1 pcs · Ø Pin: 8 mm
54,00 EUR
swiing® revival ignition set (Bosch / Ducati / swiing)
Manufacturer: swiing® revival parts · Area of application: Standard · Tension: 6 V · Performance: 17 W · Direction of rotation: left · Direction of rotation: right · Ø mounting plate: 90 mm · Number of fixing points: 3 pcs · Ø cable: 5 mm · Ø Internal flywheel: 90 mm · Alternative version of the Pony Spare part no.: A2656 · Alternative version of Sachs spare part no.: 0283 130 004 · Alternative version of Sachs spare part no.: 0286 254 008
174,60 EUR
Hot 
VEC electronic ignition coil (replaces ignition coil, capacitor & contact breaker)
Manufacturer: VEC · Area of application: Original · Area of application: Performance · Area of application: Standard · Color: black · Ø cable holder: 5 mm · Place of use: Internal (in the ignition) · Total length: 77 mm · Height: 48 mm · Number of fixing points: 2 pcs · Ø mounting hole: 4.6 mm · Mounting type: Screws · Hole spacing: 54 mm · Cable length: 140 mm · Cable length: 420 mm · Ø Internal flywheel: 90 mm
112,60 EUR
Not in stock
MVT internal rotor ignition incl. rev limiter & light 12V | Puch / Sachs
Manufacturer: MVT Allumage · Manufacturer: swiing · Tension: 12 V · Performance: 65 W · Direction of rotation: left · Ø mounting plate: 96 mm · Ø Flywheel outside: 49.2 mm · Ø cable: 7 mm · Mounting type: Screws · Number of fixing points: 2 pcs · Weight: 268 g · Area of application: Tuning
411,30 EUR
GPO ignition set CDI anticlockwise 12 V
Manufacturer: GPO · Material: Aluminum · Area of application: Original · Area of application: Standard · Tension: 12 V · Performance: 17 W · Direction of rotation: left · Ø mounting plate: 90 mm · Number of fixing points: 4 pcs · Ø Internal flywheel: 90 mm · Mounting type: Screws
238,60 EUR
GPO / swiing ignition set, left-hand breaker 6V
Manufacturer: GPO · Manufacturer: swiing · Material: Aluminum · Tension: 6 V · Performance: 17 W · Direction of rotation: left · Ø mounting plate: 90 mm · Mounting type: Screws · Ø Internal flywheel: 90 mm · Number of fixing points: 4 pcs · Area of application: Original · Area of application: Standard
225,30 EUR
Moped fans like you also bought:
Light coil 6V with cable
Area of application: Original · Area of application: Standard · Tension: 6 V · Ø Internal flywheel: 90 mm · Performance: 17 W · Mounting type: Screws · Ø mounting hole: 4.1 mm · Hole spacing: 54 mm · Total length: 76.8 mm · Height: 25.2 mm · Number of fixing points: 2 pcs
21,30 EUR
GPO flywheel 6V / 17W anticlockwise (Version 2.0) | Puch, Sachs, Belmondo
Manufacturer: GPO · Material: Steel · Tension: 6 V · Performance: 17 W · Direction of rotation: left · Weight: 900 g · Ø cone small inside: 11.5 mm · Height: 36.1 mm · Ø cone large inside: 15 mm · Cone length: 18.5 mm · Cone ratio: 1:5 · Ø Internal flywheel: 91.1 mm · Ø Flywheel outside: 116.5 mm · Thread type: MF26x1.5 (fine pitch thread) · Thread length: 8 mm · Pony spare part no.: A2600 · Sachs spare part no.: 0286 175 005
99,10 EUR
Hot
VEC electronic ignition coil (replaces ignition coil, capacitor & contact breaker)
Manufacturer: VEC · Area of application: Original · Area of application: Performance · Area of application: Standard · Color: black · Ø cable holder: 5 mm · Place of use: Internal (in the ignition) · Total length: 77 mm · Height: 48 mm · Number of fixing points: 2 pcs · Ø mounting hole: 4.6 mm · Mounting type: Screws · Hole spacing: 54 mm · Cable length: 140 mm · Cable length: 420 mm · Ø Internal flywheel: 90 mm
112,60 EUR
Not in stock
Nut M10x1 SW14 Flywheel
Manufacturer: GPO · Material: Steel · Area of application: Standard · Surface: blue galvanized · Nut type: Flange nut · Thread type: MF10x1 (fine pitch thread) · Drive: External hexagon · Height: 8.9 mm · Width across flats SW: 14 mm · Ø outside: 18.8 mm · Pony spare part no.: A4513 · Sachs spare part no.: 0942 072 102
2,70 EUR
Collection only possible with online purchase and appointment.
