Sticker set for the tank of your Puch X30 NS, N-2AH, NG-2A and NG-2AH moped / moped.
The decals are often also used on converted Puch X30 NL.
The decal set contains the two lettering characters «PUCH» as well as a rolled-up end line.
These are high-quality, UV and petrol-resistant film plot decals without carrier film. The stickers have been mounted on a transfer film to make installation easier.
Tank sticker dimensions: 290x51 mm
Trim line dimensions: 1000x3 mm
Durability: UV-resistant, petrol-resistant
Surface: matt
Color: golden
The area to be covered should be free of grease and dirt in order to provide a firm hold for the stickers.
Suitable cleaning cloths and other tank adhesives can be found in the accessories section.
Details
Rear side texture | Adhesive |
Color | gold |
Consistency | UV-resistant, petrol resistant |
Place of use | Tank (+ frame) |
Suitable for the following models
Puch |
Accessories & related products
Moped fans like you also bought:
Chrome luggage rack | Puch Maxi S
Color: Chrome · Material: Steel · Surface: chrome-plated · Wheel size [inch]: 17 " · Ø mounting hole: 8.3 mm · Ø mounting hole: 9 mm · Height: 32.5 mm · Hole spacing: 29 mm · Width: 168 mm · Mounting type: Nuts & bolts · Total length: 425 mm · Number of fixing points: 4 pcs
22,40 EUR
NTN wheel bearing 12/28/8 rear cast hub Leleu | Puch Maxi
Bearing type: Deep groove ball bearing · Stock number: 6001 · Inner ring width: 12 mm · Manufacturer: NTN · Ball bearing closed: Yes · Dust protection type: 2RS - NBR contact seal on both sides · Bearing clearance: CM (special/noise-reduced) · Bearing cage: "-" Sheet steel cage ball-guided · Groove ring: No · Material: Plastic · Material: Steel · Surface: blank · Area of application: Standard · Ø inside: 12 mm · Ø outside: 28 mm · Width: 8 mm
6,65 EUR
swiing® revival wheel axle set M12x1 x 185 cast rear wheel galvanized | Puch
Ø outside: 11.8 mm · Total length: 185 mm · Manufacturer: swiing® revival parts · Material: Steel · Surface: blue galvanized · Width across flats SW: 19 mm · Thread type: MF12x1 (fine pitch thread) · Ø shaft: 11.9 mm · Shank length: 100 mm · Thread length: 26 mm · Thread length: 52.5 mm
16,80 EUR
GPO side bars chrome (1A quality) | Puch Maxi S
Manufacturer: GPO · Material: Steel · Color: Chrome · Surface: chrome-plated · Width: 170 mm · Hole spacing: 410 mm · Total length: 420 mm · Height: 35 mm · Ø outside: 12.5 mm · Ø mounting hole: 8.1 mm · Mounting type: Screws · Number of fixing points: 4 pcs
28,10 EUR
swiing® revival screws set sprocket mounting galvanized | Puch Maxi
Manufacturer: swiing® revival parts · Material: Steel · Color: silver · Surface: blue galvanized · Drive: External hexagon · Screw head: Hexagon · Width across flats SW: 10 mm · Shank: No · Number of components: 24 pcs · Strength class: 8.8 · Thread type: M6x1 (standard thread) · Thread length: 22 mm
8,90 EUR