Side covers made by hand in Switzerland from fiberglass, suitable for your Tigra moped / moped with Sachs 503 engine.
The side covers are an absolute perfect fit and of the highest quality.
For the rear mounting hole, a special nut is included with each side cover, which can be attached to the chain guard with adhesive.
Notes: The screw holes and the cut-out for the carburetor are marked, but must be drilled or milled yourself. Make sure you wear protective equipment such as goggles, a mask and gloves. When drilling, you should also make sure that the material on the back cannot break out. To do this, clamp a piece of wood behind it and secure it with a screw clamp.
Details
Manufacturer | Made in Switzerland |
Material | Glass fiber plastic |
Color | gray |
Suitable for the following models
Sachs |
Accessories & related products
Moped fans like you also bought:
GPO piston 40 mm (12 mm KoBo) | Puch X30 Velux fan-cooled
Manufacturer: GPO · Nominal diameter: 40 mm · Ø outside piston (A): 39.94 mm · Compression height (C): 22.5 mm · Curvature (D): 3.4 mm · Total piston height (E): 52.5 mm · Number of piston rings (F): 2 pcs · Piston ring mold: L-ring · Piston ring mold: Rectangular ring · Piston ring impact: Internal fuse (IS) · Piston ring height: 1.5 mm · Piston ring height: 2 mm · Ø piston pin (B): 12 mm · Piston weight: 89 g
40,80 EUR
Magura deco / clutch lever black
Number of fixing points: 2 pcs · Manufacturer: Magura · Surface: burnished · Housing material: Steel · Color: black · Material: Plastic · Material lever: Plastic · Material: Steel · Total length: 94 mm · Ø inside: 22 mm · Mounting type: Screws · Thread type: M5x0.8 (standard thread)
58,30 EUR