Outer circlip which is mounted on the brake anchor plate to fix the brake pads.
This BZ disk is suitable for the front and rear brake anchor plate of Puch Supermaxi mopeds with Grimeca wheel hub.
Details
| Nominal diameter | 6 mm |
| Fuse type | Inside |
| Manufacturer | Puch |
| Place of use | Brake anchor plate |
Suitable for the following models
| Puch |
Moped fans like you also bought:
Magura gas cable clamp / deco cable clamp Ø 5 x 6 mm
Manufacturer: Magura · Material: Brass · Material: Steel · Surface: nickel-plated · Number of components: 2 pcs · Ø Cable bushing: 1.6 mm · Screw head: Lens head · Thread type: M4x0.7 (standard thread) · Ø outside: 5 mm · Total length: 6 mm · Thread length: 4 mm · Drive: Slot
2,35 EUR
NTN wheel bearing 12/28/8 rear cast hub Leleu | Puch Maxi
Bearing type: Deep groove ball bearing · Inner ring width: 12 mm · Manufacturer: NTN · Dust protection type: 2RS - NBR contact seal on both sides · Bearing clearance: CM (special/noise-reduced) · Bearing cage: "-" Sheet steel cage ball-guided · Groove ring: No · Material: Plastic · Material: Steel · Surface: blank · Ø inside: 12 mm · Width: 8 mm · Ø outside: 28 mm · Stock number: 6001 · Ball bearing closed: Yes · Area of application: Standard
6,90 EUR
swiing® revival wheel axle set M12x1 x 185 cast rear wheel galvanized | Puch
Manufacturer: swiing® revival parts · Thread length: 26 mm · Thread length: 52.5 mm · Material: Steel · Surface: galvanized (blue) · Total length: 185 mm · Ø outside: 11.8 mm · Ø shaft: 11.9 mm · Thread type: MF12x1 (fine pitch thread) · Shank length: 100 mm · Width across flats SW: 19 mm
17,40 EUR
Collection only possible with online purchase and appointment.
