Original 1.2 hp clutch with — 56 mm for Piaggio mopeds such as Ciao, SI, Bravo and similar models with mono gearbox and 16° cast rims.
Note: During assembly, it is essential to adjust the axial play of the clutch bell in order to prevent the rivets from sticking to the starter clutch, this should be 0.1-0.2 mm.
It is essential to remove the liner before installing the clutch; the needle bearings inside the clutch must then be filled with grease, otherwise the clutch bearing will run dry and seize.
Matching spacers can be found in the accessories section.
Original Piaggio spare part number: 1651505/ 4803595
Made by the Italian brand CIF.
Details
Ø outside | 90 mm |
Manufacturer | CIF |
Material | Steel |
Number of springs | 3 pcs, 2 pcs |
Ø Outer pulley | 56 mm |
Number of jaws | 3 pcs, 2 pcs |
Ø inside | 82 mm |
Area of application | Standard |
Suitable for the following models
Piaggio | Ciao - Ciao, Ciao, Ciao, Ciao Si Bravo/Superbravo Boxer Grillo |
Accessories & related products
Moped fans like you also bought:
Fuel tap horizontal M12x1 (with union nut) outgoing at the bottom
Possible lever positions: open / closed / reserve · Material lever: Metal · Thread type: MF12x1 (fine pitch thread) · Filter type: Plastic net · Installation direction: horizontal / horizontal · Outlet direction: below · Mounting type: Union nut · Spare tube shape: curved · Ø fuel hose connection: 6 mm · Reserve level: 70 mm
11,20 EUR
Stand 14 mm axle (1A quality) | Piaggio Ciao PX, C24
Manufacturer: Made in Italy · Material: Steel · Color: black · Surface: varnished · Stand base - center mount (A): 232 mm · Total width of stand base (B): 200 mm · Wide receptacle (C): 78 mm · Ø Receptacle (D): 14 mm · Wide upright foot (F): 20 mm · Total height: 250 mm
33,70 EUR
EFFE Condenser with cable | Piaggio Ciao, SI, Bravo, Boxer
Manufacturer: EFFE · Area of application: Original · Area of application: Standard · Capacity: 0.26 µF · Mounting type: Tab for screwing · Connection type: Cable for screwing · Ø outside: 18 mm · Height: 26 mm · Ø mounting hole: 4.4 mm · Piaggio spare part no.: 102939
13,40 EUR
Dell'Orto 13/13 SHA carburetor hand choke | Piaggio Ciao PX, C24
Manufacturer: Dell'Orto · Camouflaged: No · Material: Aluminum · Color: black · Carburetor type: SHA (type 3) · Nominal diameter: 13 mm · Ø Internal connection: 16 mm · Ø without reducing sleeve: 18 mm · Ø Inside entrance: 13 mm · Ø Output inside: 13 mm · Ø Air filter connection: 50.8 mm · Ø fuel hose connection: 5.2 mm · Ø fuel hose connection: 6 mm · Mixed oil connection: No · Vacuum connection: No · Choke control: Hand choke · Nozzle thread: M5 · Nozzle size: 66 · Mounting type: Plug connection clamped · Total length: 46 mm · Width: 60 mm · Height: 96 mm · Area of application: Tuning
67,50 EUR